MAT-500MM4 "MultiForm" has been developed on the basis of out multinode thermoformer MAT-500MM.
Purpose - producing lids (including all McDonalds types and other), trays (including trays for fruits and berries with vent holes), microcontainers, plates, substrates, complex blisters with punching or holes.
How it works: molding followed by punching, contour cutting and stacking. Punching node can be disconnected from the control panel if necessary.
Structure of the MAT-500MM4 «MultiForm» machine:
Climatic performance in accordance with
|
3.1 |
Drive Type: |
electro-, servo-, pneumatic drives |
Power supply: |
380V, 3F, 50Hz |
Maximum power consumption: |
93,0 kW |
Average power consumption: |
20,0 kW |
Compressed air pressure: |
0,6 ÷ 1,0 mPa |
Maximum air consumption: |
4,985 m3/min |
Type of coolant: |
a liquid, free-standing water cooler (not included in the scope of the equipment) |
Heating method: |
non-contact two-sided method with infrared emitters |
Molding method: |
pneumatic with plug assist or without it |
Cutting method: |
cutting at the point of molding or a spaced apart molding (forming) and cutting by means of steel rule die |
Stacking method: |
formation of cut-to length products in number for stacks by pushing the products down without reversal with subsequent shift of stacks to the production table |
Types of manufactured products: |
‒ negative in height up to 130 mm
|
Maximum dimensions of manufactured products: |
460 × 570 mm for PP
|
Maximum stack height of manufactured products: |
300 mm |
Plastics types: |
- high impact-resistant polystyrene
|
Plastics thickness: |
0,18 - 1,0 mm |
Maximum width of plastics: |
660 mm |
Maximum roll diameter of plastics: |
1200 mm |
Film roll core diameter: |
76 mm |
Performance: |
up to 25 cycles/min |
Overall dimensions (length × width × height): |
not more than 18000 × 2855 × 2925 mm |
Weight: |
not more than 7000 kg |
Degree of protection: |
IP 3.0 to EN 60529 and IEC 60144 |
Cleanness level of supplied compressed air according to GOST 17433-80: |
not worse than 8 |
Number of maintenance personnel: |
- Operator (control and quantity of products, change of material roll, waste disposal) – 1 person
|
The reliability of our equipment is due to many years of experience on the market of thermoforming equipment and moulds, as well as the use of component parts of only well-known manufacturers.