Basic advantages of the СТА-300СВ: model
1. The high quality of the manufactured packaging as the forming and punching processes occur simultaneously in the single unit.
2. Low-cost moulds.
3. Low power consumption during the equipment operation.
4. Small equipment dimensions and weight, requires no special foundation, can be installed on any floor of an industrial building.
5. Operated by one operator.
Brief specifications::
- Type of climate version – UHL (moderate cold) 4.2 in accordance with State Standard GOST 15150-69
- Forming area – 475×365 mm.
- Punching area maximum – 450×350 mm.
- Forming depth maximum – 130 mm.
- Capacity – from 9 to 22 cycles per minute, depending on the dimensions of a molded product, the number of cavities in the mould and the material thickness and type.
- Used moulds - negative
- Used punching moulds – cutting dies
- Forming method – compressed air followed by punching
- Average setup time – 1.5 hours
- Maximum power consumption – 8 kW/hour.
- Average (operating) power – 4 kW/hour.
- Operating air pressure, MPa – 0.6….0.8
- Electric power supply - 380 V, 50 Hz.
- Air consumption, no more – 1.5 m3/min at 0.6 MPa in pneumatic system of equipment and the forming speed no more than 1000 cycles/min
- Cooling – running water with the temperature of no more than 24°C
- Water consumption, no more than 10 l/min (it is possible to create a closed circuit of moulds water cooling).
- Types of used materials - roll PS, OPS, PET, PVC.
- Film thickness – from 0.18 to 0.5 mm (PVC, PET); from 0.18 to 0.7 mm (PS, OPS).
- Film heating – contact
- Film feed method – step-by-step, from a roll
- Width of film roll, no more, mm - 480
- Outer roll diameter, no more, mm - 500
- Roll weight, no more, kg - 120
- Overall dimensions, no more than 2400×1123×1900 mm
- Weight – 750 kg.
- Drive type – electropneumatic actuator
The tooling for СТА-300СВ is duralumin moulds with integrated set of cutting dies.
