ООО "Термопак"

NORMA series

СТА-300 СВ Norma

Automatic thermoforming equipment СТА-300СВ NORMA

Its purpose is the production in automatic mode of cake domes, salad bowls, microcontainers for sponge-cake goods, trays for rolls, trays, chocolate trays, blister packaging, plates made of roll materials. The equipment is designed for the 3-shift operation. Operated by one operator.

Forming and punching technology is similar to the technology of Canadian GN Plastics

Specimens of the package that can be formed on the model СТА-300СВ:

Basic advantages of the СТА-300СВ model:

  1. The high quality of the manufactured packaging as the forming and punching processes occur simultaneously in the single unit.
  2. Low-cost moulds.
  3. Low power consumption during the equipment operation.
  4. Small equipment dimensions and weight, requires no special foundation, can be installed on any floor of an industrial building.
  5. Operated by one operator.

Brief specifications:

  1. Type of climate version – UHL (moderate cold) 4.2 in accordance with State Standard GOST 15150-69
  2. Forming area – 475×365 mm.
  3. Punching area maximum – 450×350 mm.
  4. Forming depth maximum – 130 mm.
  5. Capacity – from 9 to 22 cycles per minute, depending on the dimensions of a molded product, the number of cavities in the mould and the material thickness and type.
  6. Used moulds - negative
  7. Used punching moulds – cutting dies
  8. Forming method – compressed air followed by punching
  9. Average setup time – 1.5 hours
  10. Maximum power consumption – 8 kW/hour.
  11. Average (operating) power – 4 kW/hour.
  12. Operating air pressure, MPa – 0.6….0.8
  13. Electric power supply - 380 V, 50 Hz.
  14. Air consumption, no more – 1,5 m33/minat 0.6 MPa in pneumatic system of equipment and the forming speed no more than 1000 cycles/min
  15. Cooling – running water with the temperature of no more than 24°C
  16. Water consumption, no more than 10 l/min (it is possible to create a closed circuit of moulds water cooling).
  17. Types of used materials - roll PS, OPS, PET, PVC.
  18. Film thickness – from 0.18 to 0.5 mm (PVC, PET); from 0.18 to 0.7 mm (PS, OPS).
  19. Film heating – contact
  20. Способ подачи пленки - пошаговый с рулона
  21. Width of film roll, no more, mm - 480
  22. Film feed method – step-by-step, from a roll
  23. Outer roll diameter, no more, mm - 500
  24. Overall dimensions, no more than 2400×1123×1900 мм.
  25. Weight – 750 kg.
  26. Drive type – electropneumatic actuator

The tooling for СТА-300СВ is duralumin moulds with integrated set of cutting dies.

Read more...
 
/html>